5 Jan
2011
5 Jan
'11
2:25 p.m.
ImportError: DLL load failed: The specified procedure could not be found.
Just to be sure, I've gone back and re-compiled it from clean source. There is no indication of any compile errors, and it didn't make any difference.
This is different from "DLL not found", though: it means that the DLL *was* found, but doesn't have one of the symbols that is being used. Unfortunately, it doesn't tell which symbol, and in which DLL.
In that case, how do I debug this?
There are a number of ways: 1. load the pyd into depends.exe, and see whether it shows problems. 2. use sxstrace.exe Regards, Martin