How suppress warning message? (about nonstandard install path)
I reset prefix to something else and happily installed everything fine. There is a warning message at end of installation about path not being in sys.path. Can I remove this warning somehow?? Chris -- _______________________________________ Christian Seberino, Ph.D. SPAWAR Systems Center San Diego Code 2872 49258 Mills Street, Room 158 San Diego, CA 92152-5385 U.S.A. Phone: (619) 553-9973 Fax : (619) 553-6521 Email: seberino@spawar.navy.mil _______________________________________
seberino@spawar.navy.mil writes:
I reset prefix to something else and happily installed everything fine. There is a warning message at end of installation about path not being in sys.path.
Can I remove this warning somehow??
Insert your installation path into sys.path before running install, and remove it again after the install is finished. bdist_wininst.py does this, near line 128. Thomas
That worked. Thanks. Clean and simple solution! CS On Wed, Oct 22, 2003 at 09:25:54AM +0200, Thomas Heller wrote:
seberino@spawar.navy.mil writes:
I reset prefix to something else and happily installed everything fine. There is a warning message at end of installation about path not being in sys.path.
Can I remove this warning somehow??
Insert your installation path into sys.path before running install, and remove it again after the install is finished. bdist_wininst.py does this, near line 128.
Thomas
-- _______________________________________ Christian Seberino, Ph.D. SPAWAR Systems Center San Diego Code 2872 49258 Mills Street, Room 158 San Diego, CA 92152-5385 U.S.A. Phone: (619) 553-9973 Fax : (619) 553-6521 Email: seberino@spawar.navy.mil _______________________________________
participants (2)
-
seberino@spawar.navy.mil
-
Thomas Heller