Charles Marcus, on 12/19/2007 7:39 AM, said the following:
On 12/18/2007, Brad Knowles (brad@shub-internet.org) wrote:
On the web interface, the closest we get is the "Membership Management" section. If you have more users on the list than a certain built-in site-wide default, then this will be broken down by the first letter of their e-mail address.
Where is this default set? I had a list that mysteriously switched to the view by letter mode, then a few days later, went back to listing them all on a single page... from the above comment, I'm guessing that I had added a member that put me over this limit, then removed one to put me back under.
I'd like to bump it up a tad, so that doesn't happen again. Our lists are fairly static, and will not be growing significantly in the future.
Answering myself, found it digging through Defaults.py...
DEFAULT_ADMIN_MEMBER_CHUNKSIZE = 30 is the default, which I just counted, and I currently have 30, so that was it...
Bumped it up to 50 in mm_cfg.py and restarted mailman...
--
Best regards,
Charles