Josh -
After reading the INSTALL and UPGRADING files in rc2, I concluded that all I needed to do was './configure' and then 'make install'. This worked well for me (I have a virgin install of rc1).
The note at the end of the 'make install' output said to do 'make upgrade' which I then did. It spewed some confusing output about how my lists were all OK - I concluded that 'make update' was for converting lists from an old format that I don't have....
Regards,
Richard.
Richard Ames linsup.com, Sydney, Australia Tel: +61 2 9144-6131, Fax: +61 2 9144-6138 mailto:richard@linsup.com http://www.linsup.com
-----Original Message----- From: mailman-users-admin@python.org [mailto:mailman-users-admin@python.org]On Behalf Of Joshua Levitsky Sent: Wednesday, 16 June 1999 3:52 To: mailman-users@python.org Subject: [Mailman-Users] Re: [Mailman-Announce] [ANNOUNCE] Mailman 1.0rc2
Question.... I have 1.0rc1. I unpacked the archive and did a
./configure
and then a
make update
It said it updated the mail lists. However on the web pages it says rc1. Is that ok? Should I have done a make install from rc1 to rc2?
-Josh