Hello PyPy folks. I have recently discovered that in Fedora, when building PyPy, we run test.regrtest but we don't make test failures terminate the build. For a couple times, I've reported test hangs because that was unfortunately the only problem that we were able to spot. Tests that run but don't fail the build are kinda useless. I want to remedy that but I noticed that many tests fail for quite obvious reasons, for example: ====================================================================== FAIL: test_getsitepackages (test.test_site.HelperFunctionsTests) ---------------------------------------------------------------------- Traceback (most recent call last): File "/builddir/build/BUILD/pypy3.10-v7.3.19-src/lib-python/3/test/test_site.py", line 335, in test_getsitepackages self.assertEqual(dirs[0], wanted) AssertionError: 'xoxo/lib64/pypy3.10/site-packages' != 'xoxo/lib64/python3.10/site-packages' - xoxo/lib64/pypy3.10/site-packages ? ^^ + xoxo/lib64/python3.10/site-packages ? ^^^^ ---------------------------------------------------------------------- I have examined the GitHub actions configuration in pypy/pypy but I don't see the tests run. What are the expectations about the test results? Should we check that the failure rate does not exceed some percentage? Or should we skip know failures one by one? Or report them to you? Or do we keep running the tests just that we could see the failure in the logs but don't fail the build for that? How do you use those tests in PyPy? Thanks, -- Miro Hrončok -- Phone: +420777974800 Fedora Matrix: mhroncok