Hi Robert,
 I used Enthought Canopy.

C:\Users\Madhu N.M\Canopy- There are two folders inside this named licenses and scripts.
C:\Users\Madhu N.M\.sfepy- This folder is empty.

Regards,
Madhu

On Friday, 20 November 2015 13:38:35 UTC+5:30, Robert Cimrman wrote:
Hi Madhu,

How did you install sfepy?

r.

On 11/19/2015 07:18 PM, Madhu Mahadevappa wrote:
> Dear Robert,
>   Thank you very much for the reply. I'm Using Canopy. Please let me know
> how and where to find the SfePy directory? I'm sorry if it is a stupid
> question.
>
> Regards,
> Madhu
>
> On Thursday, 19 November 2015 15:23:43 UTC+5:30, Robert Cimrman wrote:
>>
>> Hello Madhu,
>>
>> Try using sfepy in-place build [1]. This example is in SfePy, so you can
>> run it
>> simply by (in the sfepy source directory):
>>
>> python simple.py examples/linear_elasticity/its2D_2.py
>>
>> But feel free to copy it elsewhere (as long as you stay in the sfepy
>> source
>> directory when running commands.
>>
>> You can also use your file, but correct the path, if both the example and
>> the
>> mesh are in the same directory:
>>
>> filename_mesh =  'its2D.mesh'
>>
>> The syntax error is strange - how/where did you run the command? Also, do
>> not
>> mix \ and / characters in paths.
>>
>> Does that help?
>>
>> r.
>> [1] http://sfepy.org/doc-devel/installation.html#in-place-build
>>
>> On 11/18/2015 07:00 PM, Madhu Mahadevappa wrote:
>>> Hello,
>>>    I'm Madhu and very new to Sfepy, learning this for my Master Thesis.
>> I'm
>>> trying to run the example given in the primer but getting an
>> error.Please
>>> help me with this.
>>>    1. I'm trying to invoke SfePy with the command 'E:|Solution/simple.py
>>> its2D.py' . My Problem definition file and .mesh file are located in my
>> E
>>> drive with a folder named Solution. When  I run this, I'm getting the
>>> following error
>>> ""
>>>                                  E:\Solution/simple.py its2D.py
>>>                                  ^
>>>                               SyntaxError: invalid syntax
>>>
>>> ""
>>> 2. I have attached both the problem definition file and .mesh file I
>> have
>>> been trying from past 2 days to rectify but I couln't. Kindly help me.
>>>
>>> Regards,
>>> Madhu
>>>
>>
>>
>