[Mailman-Users] RE: Machine in unresponsive
jsingh at fdu.edu
Wed Jan 22 23:12:08 CET 2003
But I think I will still have to make a newfs for the partition where I
am getting I node issues, any suggestions?
From: Jon Carnes [mailto:jonc at nc.rr.com]
Sent: Wednesday, January 22, 2003 5:10 PM
To: jsingh at fdu.edu
Cc: Mailman-Users at python.org
Subject: RE: [Mailman-Users] RE: Machine in unresponsive
Are you getting warning messages that your Mailman apps are calling
deprecated processes in Python? I've seen that after upgrading Python.
The best thing you can do after that is to re-install Mailman.
I've done that at a couple of sites and it works fine after that.
On Wed, 2003-01-22 at 16:51, jsingh wrote:
> Why is qrunner sending mail to the mailman user every minute. That
> with the cron job it is creating an email for the mailman user. It is
> because of the deprication issue.
> -----Original Message-----
> From: Jon Carnes [mailto:jonc at nc.rr.com]
> Sent: Wednesday, January 22, 2003 4:30 PM
> To: jsingh at fdu.edu
> Cc: Mailman-Users at python.org
> Subject: Re: [Mailman-Users] RE: Machine in unresponsive
> I had problems with inodes once, it turned out that I had left a
> in debug mode and it had created several tiny log files cluttering up
> partition... and by several I mean >5k. I deleted those files and all
> was well. I haven't seen any problems with inodes under ordinary use,
> or even under most extraordinary use.
> Good Luck - Jon Carnes
> On Wed, 2003-01-22 at 15:09, jsingh wrote:
> > Sir
> > Have you come across a situation where inodes makes the machine
> > sluggish. Right now when I do a df -i I get 95% inode usage and
> > what I believe is causing the problem. Any suggestions as to what to
> > Thanks
> > -----Original Message-----
> > From: Jon Carnes [mailto:jonc at nc.rr.com]
> > Sent: Wednesday, January 22, 2003 1:17 PM
> > To: jsingh at fdu.edu
> > Cc: Mailman users Mailing list
> > Subject: RE: Machine in unresponsive
> > On Wed, 2003-01-22 at 12:21, jsingh wrote:
> > > For upgrade purposes do I still need to run configure with
> > > options?
> > >
> > yes.
> > If you still have the original source files from the install, then
> > can look in the config.status file, it should tell you your original
> > ./configure statement.
> > Good Luck
> > ------------------------------------------------------
> > Mailman-Users mailing list
> > Mailman-Users at python.org
> > http://mail.python.org/mailman/listinfo/mailman-users
> > Mailman FAQ: http://www.python.org/cgi-bin/faqw-mm.py
> > Searchable Archives:
> > This message was sent to: jonc at nc.rr.com
> > Unsubscribe or change your options at
More information about the Mailman-Users