[Mailman-Users] Help a newbie out! How to list users of a specific list

Charles Marcus CMarcus at Media-Brokers.com
Wed Dec 19 18:13:54 CET 2007

Charles Marcus, on 12/19/2007 7:39 AM, said the following:
> On 12/18/2007, Brad Knowles (brad at shub-internet.org) wrote:
>> On the web interface, the closest we get is the "Membership 
>> Management" section.  If you have more users on the list than a 
>> certain built-in site-wide default, then this will be broken down by 
>> the first letter of their e-mail address.

> Where is this default set? I had a list that mysteriously switched to 
> the view by letter mode, then a few days later, went back to listing 
> them all on a single page... from the above comment, I'm guessing that I 
> had added a member that put me over this limit, then removed one to put 
> me back under.
> I'd like to bump it up a tad, so that doesn't happen again. Our lists 
> are fairly static, and will not be growing significantly in the future.

Answering myself, found it digging through Defaults.py...

DEFAULT_ADMIN_MEMBER_CHUNKSIZE = 30 is the default, which I just 
counted, and I currently have 30, so that was it...

Bumped it up to 50 in mm_cfg.py and restarted mailman...


Best regards,


More information about the Mailman-Users mailing list