PewPew

Download

pewpew@python.org

March 2020

3 participants
2 discussions

Newsletter
by Radomir Dopieralski March 11, 2020

March 11, 2020

State of PewPew for 2020-03-11 ****************************** News ==== * CircuitPython 5.0.0 has been released https://circuitpython.org You can update your PewPews by following https://pewpew.readthedocs.io/en/latest/pewpew10/hardware.html#updating-the… * PewPew M4 is on sale now. You can get it at https://makerfabs.com/circuitpython-pewpew-m4.html * Christian Walther got the PewPew Lite to work with the Giant Board https://twitter.com/isziaui/status/1236261673960423424 -- Radomir Dopieralski

2 1

Are there 3D-printable protective cases for PewPew standalone (as sold by Makerfabs)?
by Raphael Das Gupta March 2, 2020

March 2, 2020

Hi all I've run a course with PewPew standalone devices from Makerfabs <https://makerfabs.com/pewpew-standalone.html>. Some of them broke during the course. (We had one ripped-of USB port and one broken battery holder.) So we're considering to 3D-print some protective cases for the next course. Are there any existing designs / models we could use for that? Ideally, the display would be visible and the buttons and on/off switch operable while in the case, and it should be possible to plug and unplug the USB cable. It's not necessary to be able to access the batteries without removing the case, nor do we need access to the 12-pin connector <https://pewpew.readthedocs.io/en/latest/pewpew10/hardware.html#the-12-pin-c…>. But if any other models or case designs already exist, I'd be interested in them, too. Kind regards, Raphael

2 1